Standoff assemblies for actuators

Valves which will be installed in ovens or heated zones require a standoff assembly, which locates the actuator out of the heated zone and supports both the valve and the handle or actuator. The 5/8" outside diameter standoff tube extends through the oven wall and is secured by means of a clamp ring supplied with the assembly.

The multiposition microelectric actuator uses a special standoff assembly which is keyed to both valve and actuator. The key guarantees proper alignment and positioning of the valve.

If you are converting an actuated valve from a closemount to a standoff application, order the appropriate actuator clamp ring and two screws (shown in the drawings listed below) in addition to the standoff assembly.

Standoff assemblies are available in standard lengths of 2", 3", 4" and 6".

Product numbers

Select to jump to product numbers:

Standoff assemblies for:
   Air actuators
   Microelectric actuators
   Standard electric actuators
Standoff mounting hardware (clamprings and screws) for:
   Air actuators
   Microelectric actuators
   Standard electric actuators

Further reference

What mounting hardware do I need?
Standoff assembly for manual actuation
Knobs and handles for standoffs
Right angle drive

Drawings

Standoff assembly with Valco valves:
 • Two positon valve, manual
 • Two position valve, air actuator
 • Multiposition valve, air actuator
 • Multiposition valve, microelectric actuator
Standoff assembly with Cheminert valves:
 • Two position valve, manual
 • Multiposition valve, microelectric actuator

Standoff assemblies for air actuators

If you are converting an actuated valve from a closemount to a standoff application, order the appropriate actuator clamp ring and two screws (shown in the drawings listed above)
in addition to the standoff assembly.

Standoff mounting hardware for air actuators

If you are converting an actuated valve from a closemount to a standoff application, order this actuator clamp ring and two screws in addition to the standoff assembly.

Standoff assemblies for microelectric actuators

If you are converting an actuated valve from a closemount to a standoff application, order the appropriate actuator clamp ring and two screws (shown in the drawings listed above)
in addition to the standoff assembly.

Standoff mounting hardware for microelectric actuators

If you are converting an actuated valve from a closemount to a standoff application, order this actuator clamp ring and two screws in addition to the standoff assembly.

Standoff assemblies for standard electric actuators

If you are converting an actuated valve from a closemount to a standoff application, order the appropriate actuator clamp ring and two screws (shown in the drawings listed above)
in addition to the standoff assembly.

Standoff mounting hardware for standard electric actuators

If you are converting an actuated valve from a closemount to a standoff application, order this actuator clamp ring and two screws in addition to the standoff assembly.